Forming Strains in ASME
The equations for calculating forming strains are available in the following tables:
Division 1: Table UG-79-1
Division 2: Table 6.1
NextGen uses for both standards the equations of Division 2, because it has more cases, including one-piece dished heads.
The result printed in the report is informative only, high forming strains may require a heat treatment on the part.
If you are designing a vessel in Division 1 and you do not need the calculation of the strains of a one-piece dished head, you can suppress the calculation by inserting a zero in the field "Blank diameter multiplier".
Next: Set liquid level
Search the documentation
Customer area
Categories
Articles in this category
- How to create a reinforced ring opening (studding outlet flange)
- How to create a jacketed vessel
- How to use a National Annex in EN1991-1-4
- Forming Strains in ASME
- Set liquid level
- Limits on thickness for tubes and cylindrical shells in the VSR standard
- Thread calculation according to EN14359 Clause 5.5.6
- Cladding and weld overlay management
- How to design a stiffening ring against external pressure using NextGen
- Standard flanges and flanges according to calculation code
- Common mistakes when searching EN 1092-1 flange ratings
- How to design a gas cylinder with NextGen